The following are the common fabrication options available for the Versatrak range of decorative rods:

The following information is required for bends or mitres:

  • The back wall measurement
  • The angle of each corner. This may be done by placing two business cards into the corner and stapling/taping them to reflect the angle. Using a compass will determine the degrees of the angle.
  • The bracket projection

We can then work all the rest out for you



Only Versatrak 25 has a 90 degree internal metal joiner

Boldtrak & Vantage Eyelet Rod

Butt the two mitred rods together and position the brackets as close as possible to the corner to hold the rods in place.

Example of Versatrak 25 with 90 degree internal joiner